1/2 in. threaded

1/2 in. threaded

The 1/2 in. threaded mount is used on threaded pipes when the:

  • pipe length is 7/16 - 1/2 in. (measured from the wall), and
  • pipe threads or adapter threads are 1/2 in. NPT

NOTE:
A Trim Plate (escutcheon plate) is available for use with the ADTS' tub spout. It has a depth of 3/8 in. and can be used to fill a gap between the wall and the back of the tub spout. It can also be used to cosmetically cover larger access openings to the tub spout's water supply. If using the Trim Plate, be sure to add its depth (3/8 in.) to the pipe length measurements provided above.

SPECIAL CONSIDERATION:
If the initial pipe length (pre-cutting) is more than 1 1/2 in. and the threads can be completely removed after cutting it down to a 1 1/2 in. length, use the Slip-Fit mount instead of the 1/2 in. threaded mount. 



Also in ADTS Mounting Options

Configurations
Configurations

ADTS part numbers end in SB or CT. 

  • SB: all mounts included
  • CT: mounts ordered separately
  • Ind. mounts sold in 10-packs
        Slip-Fit Mount
        Slip-Fit Mount

        Use on 1/2 in. non-threaded pipes:

        • pipe length 1 1/4 - 1 3/4 in.
        • copper, galvanized or CPVC
        • PEX or CPVC with copper stub
            3/4 in. threaded
            3/4 in. threaded

            Use on NPT threaded pipes:

            • pipe length 7/16 - 1/2 in.
            • works with 3/4 in. galvanized
            • works with 3/4 in. NPT adapters

              Net Orders Checkout

              Item Price Qty Total
              Subtotal $0.00
              Shipping
              Total

              Shipping Address

              Shipping Methods